HI to every one
Over the last few months i have been playing about with low frequency for under water RF link to control submarine, a few days ago i decided what about if all of this was joined to a piezo transducer yes it can be done, the transducer in the water if it is held half inch under the surface it starts to make a whirlpool standing out the water about 2inches high and you can see the code on the top of the whirlpool hopefully when i get a bit more time i will take it a bit further and see where it goes if you touch this whirlpool it feels like it starts to burn your finger, i no what you are going to say dont touch it then, but at the moment the unit is running on low power but i will hit it with more power and see if i can start a hot tub for the misses but i don't think she will like the RF burns.
john
Over the last few months i have been playing about with low frequency for under water RF link to control submarine, a few days ago i decided what about if all of this was joined to a piezo transducer yes it can be done, the transducer in the water if it is held half inch under the surface it starts to make a whirlpool standing out the water about 2inches high and you can see the code on the top of the whirlpool hopefully when i get a bit more time i will take it a bit further and see where it goes if you touch this whirlpool it feels like it starts to burn your finger, i no what you are going to say dont touch it then, but at the moment the unit is running on low power but i will hit it with more power and see if i can start a hot tub for the misses but i don't think she will like the RF burns.
john
» ExpressLRS - 868/915 Mhz equipment
» Flight controllers as sub levelers
» Bournville 2023
» Raspberry Pi Pico + ePaper display hat
» Help with 1:48 scale WW2 German U boat
» Problem with Futaba FX-30 and 40 MHz module
» Resurgam, Nordenfelts II & IV - George Garrett's works.
» Letter to BMFA to request the sharing of the 35MHz frequency for model subs in the UK.