I came across this while trying to print an egg shaped part ( A vent for the Fulton Nautilus):
https://cadenvy.com/
She does a very good, stepwise introduction to 3D software use e.g Fusion 360. (Very useful for anyone experiencing the steep earning curve. Going through the tutorial, I realised that a lot of my knowledge is "built on sand" !)
David
https://cadenvy.com/
She does a very good, stepwise introduction to 3D software use e.g Fusion 360. (Very useful for anyone experiencing the steep earning curve. Going through the tutorial, I realised that a lot of my knowledge is "built on sand" !)
David
» Type II U-boat
» WW2 mini sub build
» Not the hobby I expected :)
» Papplewick Pumping Station 2023 - 9th & 10th April
» 915mhz / 868mhz as a viable frequency for submarines.
» Frsky - 915Mhz equipment
» TBS Crossfire - 915Mhz equipment
» ExpressLRS - 915Mhz equipment