Home
Register
Log in
HELLO,
It seems to my problems are not going to stop here!.
So here it is:
1)-the rack doesn't what to go inside the aft threw the lock ring as You may seen on picture!.(25%_0069=0068)
My intention is to expand the diameter of 1mm the Lock Ring,sufficient to get the rack smoothly inside!.
But because I have not yet functional lathe,I have to wait until next week to find some one for these.
2)-what is the correct movement of the servo?(picture 20%_0067)
Please Response ASP.
REGARDS
P.S. I steel having problem to ad pictures!.Is necesaire to upload them on what ever site and after that can we ad here?.
It seems to my problems are not going to stop here!.
So here it is:
1)-the rack doesn't what to go inside the aft threw the lock ring as You may seen on picture!.(25%_0069=0068)
My intention is to expand the diameter of 1mm the Lock Ring,sufficient to get the rack smoothly inside!.
But because I have not yet functional lathe,I have to wait until next week to find some one for these.
2)-what is the correct movement of the servo?(picture 20%_0067)
Please Response ASP.
REGARDS
P.S. I steel having problem to ad pictures!.Is necesaire to upload them on what ever site and after that can we ad here?.
» Radio RSSI depth controller
» Mast mounted water level sensor.
» Newcomer to the forum?
» Type II U-boat
» Lipo cut off circuit - Practical Electronics magazine - November 2021
» bladder systems
» Looking for drawings and instructions for Hegi U-25 Kit
» Nautilus II by Robert Fulton