Home
Register
Log in
I was digging through my negatives and ran across these ones that chronicled the excellent job Steve Vick did converting the Scale Shipyard 1/96 GATO/BALAO/TENCH kit into a very good representation of my old boat, the USS TRUTTA.
Steve did the model proper, I did the WTC. I developed a 'gear splitter' to derive a two-shaft (counterrotating) output from a single motor.
The time frame is the mid-90's.
David
Steve did the model proper, I did the WTC. I developed a 'gear splitter' to derive a two-shaft (counterrotating) output from a single motor.
The time frame is the mid-90's.
David
» U-47 Robbe German Type VII R/C in 1/40
» U-47 Robbe German Type VII R/C in 1/40 scale
» Pinger 4 - A simpler design for an ultrasonic Pinger which gives an accurate 1 second pulse.
» Lipo cut off circuit - Practical Electronics magazine - November 2021
» GRP end caps
» UHF radio control for submarines (openLRS, LoRa, FSK etc. on 458Mhz and 433Mhz )
» WW2 mini sub build
» My X craft