I've decided to go all modern for this boat, and install a brushless motor, LiPo battery, and all the other bits that go with it. Now, this is something I've never done yet, so I'm going to need some help here...a lot of help.
I have the LiPo battery, a Turnigy 3 cell 11.1volt 5.000mAh 20-30c burst LiPo pack, and thanks to David Forrest, I have the charger en route, a Turnigy C3 Compact Balance charger.
So, next up is a compatible esc with the low voltage safety cut off, a compatible rx to work with my Futaba T7CP computer tx, and of course, a good brushless motor. This is where I need your advice, chaps...any recommendations for the esc and the rx?
I have the LiPo battery, a Turnigy 3 cell 11.1volt 5.000mAh 20-30c burst LiPo pack, and thanks to David Forrest, I have the charger en route, a Turnigy C3 Compact Balance charger.
So, next up is a compatible esc with the low voltage safety cut off, a compatible rx to work with my Futaba T7CP computer tx, and of course, a good brushless motor. This is where I need your advice, chaps...any recommendations for the esc and the rx?
Wed Apr 10, 2024 5:48 am by tsenecal
» Modulated electric fields for submarine communication in a "heads up" from Harry!
Tue Apr 09, 2024 7:33 pm by geofrancis
» Laser cut Robbe U47 conversion
Tue Apr 09, 2024 3:40 pm by david f
» ExpressLRS - 868/915 Mhz equipment
Tue Apr 02, 2024 3:27 pm by tsenecal
» Information on camouflage patterns for German seahund
Fri Mar 15, 2024 4:36 pm by david f
» WW2 mini sub build
Tue Mar 12, 2024 1:56 pm by geofrancis
» Not the hobby I expected :)
Sun Mar 10, 2024 6:30 pm by cat
» Sheerline gasket material
Mon Feb 19, 2024 9:24 pm by Michaelc
» Choice of CAD software and Printer for 3D printing
Thu Feb 15, 2024 1:53 pm by david f